FREE STANDARD SHIPPING FOR ORDERS OVER $50 AND FREE RETURN SHIPPING
 

Using USB audio playback

Note: This ToneMatch mixer can only read .WAV and .MP3 files.

To play audio through the ToneMatch mixer via USB:

Connect the power supply and turn the mixer on.

Rotate the ToneMatch selector to PREFS.

Insert your USB thumb drive into the USB-A connection on the rear panel. You should see “USB Media Attached” on the display for three seconds. You will also see: “USB Media detached” when removing a USB thumb drive.

Turn the Menu knob (left control knob below display) clockwise to highlight “USB A Playback” on the display and push the knob in to select the setting. Please note the menu will time out after ten seconds of inactivity. Your files should now be viewable on the display screen.

Turn the Select knob (centre control knob below display) to highlight a track and push the knob in to initiate playback.
 

To adjust the level of the track, turn the Level knob (right control knob under display) either clockwise or anticlockwise.

Push the Select knob to pause.

Push the Level knob to mute.

Was this helpful?

Submit

Thank you for submitting your comments.